Have a wobble, driver front area maybe - Maintenance and Repair Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Have a wobble, driver front area maybe
Wednesday, April 07, 2010 1:05 PM
I can look at it again, but im pretty sure the tire checked out fine last I looked, as in no broken belts or lumps.

Its at low speeds, usually under deceleration, feels like the driver front area is running over a bump over and over

I replaced the strut mounts when I installed my dspecs and pro kit springs, like 8k miles ago, but that still doesnt mean they could have taken a beating and the one is broken?

I dunno, if anyone has experienced this let me know, so I know what to look for when I start taking the car apart.



Re: Have a wobble, driver front area maybe
Wednesday, April 07, 2010 4:55 PM
check your lug nuts make sure they are tight. and check to see if the strut assembly is tight also.



Re: Have a wobble, driver front area maybe
Wednesday, April 07, 2010 7:30 PM
lugnuts are tight, can you tighten the assembly without taking it off?


Re: Have a wobble, driver front area maybe
Thursday, April 08, 2010 9:45 AM
Wheel off balance? (have stick-on weights? Maybe one felll off?)

Wheel bearing have any play?



Re: Have a wobble, driver front area maybe
Thursday, April 08, 2010 2:08 PM
Jazer wrote:Wheel off balance? (have stick-on weights? Maybe one felll off?)

Wheel bearing have any play?


had all 4 rims balanced recently, all the weights are still there, I can check the bearing though.


Re: Have a wobble, driver front area maybe
Thursday, January 27, 2011 1:21 PM
Same problem here after installed my drop. Have you found what's causing this ? Borderlin3



Re: Have a wobble, driver front area maybe
Thursday, January 27, 2011 11:45 PM
I would take the wheel off and have it spin balanced, to me it sounds like a broken belt and having it on a spin balancer would be the easiest way to check for a broken belt.




Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!

Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search