Does anyone know where the ABS wheel sensor wire goes? The wire for the passenger front sensor has been sliced, so i need to get a new one, but i need to know where the wire goes so i can replace it. 1998 Sunfire GT 2.4L.

If this is any help

On my '93 CAV it connects to the engine harness at a connector, in front of the Radiator Surge tank, near the hood bump stop.

Not sure if it is still the same on yours, but possible


Alont

On third gens... it goes from the sensor at the wheel hub... in a wireloom up the top of the lower control arm... then to the plastic fender liner (some gray plastic clips)... follows the liner forward to the main engine bay wiring harness between the PCM (which is in the front fender well, behind the plastic liner, in a metal case welded to the front frame rail) and the main C100 connector at the firewall driver's side rear of the engine bay (where it pops thru the big rubber connector in the firewall).

Hope that helps

Once through the firewall it goes to the Brake Control Module, right behind the fuse panel on the drivers side (up in the dash).