I had to replace my door panel so I went to the junkyard and bought one, however the fabric isn't the same color so I have to swap them. I removed the old one but I had to break the plastic welds that hold the little change cup/door handle piece on because the fabric panel goes under that. Any ideas on how I can go about properly reapplying the fabric panel on the new door panel?

i just lined mine up and tapped them down and they havent moved yet (been like a year). i lined them up by useing the lttle bit of plastic that wasd left over by tearing them off and then just used duct tape to hold them in place.





click sig for my car audio videos

hot glue works too


____________________________________
Primer Counts as Custom Paint Right?
BTW: This is my Sig.

id go the hot glue route if i were you.

I tried a little bit of hot glue but the fabric panel is a little warped, granted I was using a mini-hot glue gun. But regardless I can't have 2 different kinds of fabric so I'm gonna have to eventually try it again, next time I'll have to break out the big gun, literally.