hey guys i have been looking at a bunch of diff cars to get ideas and i keep seeing the dash bezels with the three gauge pods molded into them i was wondering how thats done cause i got some pod holders off of my brother and i just dont get it so is there any one out here who would make one for a price or anyone that could help? thanks in advance
those are all custom made. if your any good with fiberglass, its pretty simple.
They are pretty easy to make depending on your skill level with fiberglass. I know Joey Baggs(Eazy) and myself can make them to sell, however I dont have the time to do that right now, and probably won't have clear time till the end of this month. So I suggest going to Joey and asking him if he can make you one.
Click Sig for Jersey GM's Official Website
I made one for myself and it wasn't hard at all. It just took me a while.
every picture i have seen of someone making it it looks like a complete three gauge pillar cut down. the only way i could see getting one to fit is to cut it up pod by pod. is there a pillar i dont know about that you just have to cut down a little? pics or links are greatly appreciated
lol no pillars needed. just pull the vents out and get some 2" diameter pvc piping. hot glue the pvc pipe sleeves where you want them at to temp hold it in place. cover the area with fleece or any type of absorbant material. then use fiber glass and resin to make your piece.
I just picked up a pre-cut 2 foot section of 2 inch PVC pipe at home depot and just into sections alittle less than 1/4 inch long. 2-1/16 inch gauges fit perfectly in the 2 inch pipe.
