I finally was able to get an RK sport bezel. Got it off an org member for 150 shipped. I was going outside to test fit the piece that goes on the body to hold the turn signal. Here is where it goes major downhill. The #%!*in piece gets caught in the door out of my house! Crunch. There's a huge dent/crack in it now....

My question. What are my options. Can I get it re-coated and fixed? Or do I bite the bullet and pay 90 for the new one?

Pictures later.

oh man, that @!#$in sucks. pics now!

if u really bit through that carbon fiber you're probly @!#$. if it's just clear coat damage you might, and i say that loosely have a shot at fixing it.

If its not a large crack, you could repair that section and paint it black

Here it is. I wanted to vomit. My phone partially breaks, my laptop broke, now this. Hopefully this is the end of this $hit run.

IMO the benzel looks better without those outer pieces anyway, they always seem to hang off more than the main portion of the benzel. Just use the main portion and dont worry about the side pieces.

^i agree w/ this guy! i do not have my outer pieces installed. looks better that way!



WiGM-Tuners member.

Ill consider that. Red can you get me a closer picture of the rear of your cav please. I've seen it. Just not close. Thannks.

^car is in storage, so this will have to do:





WiGM-Tuners member.

could clear it.. won't fix the cracks but it should make them a lot less visible.

i say install it with out the corners pieces.

02_redbadged wrote:^car is in storage, so this will have to do:

i love ur car, even with the toyo tails