I'm finally in the process of getting ready for paint and doing final touch ups and fitment fixes. Front bumper is a Buddy Club 2, and I've finally got around to moving the mounting holes behind the corners so the headlight gaps are completely gone.

Even with all of the supplied fastening points the bumper tends to flop around and feel loose on the bottom up front. The stock wheel well covers do not line up or fit with the bumper edge itself. I was leaning towards putting some bracing between the lower radiator mount and the bottom of the bumper on each side. Does anyone have recommendations for adding front supports?

Go for some lightweight metal tube supports, going at 45 degree angles from the outter edges of the bumper to some point on the lower rad support...