i was wondering what all was needed to do to the crush panel/sytrofoam if anything to make the rear bumper fit. i know i have to pull the pieces under my taillights out for it but otherwise what all is involved.

i have done a body kit prior on my old cav and it wasnt the slightest bit hard but hopefully someone can help me out and pics if possible would be greatly appreciated

I think we had to cut some of the crush guard off on phlatcav's beater....just a lil trimming though, nothing major.

alrighty then

LAFNGAS wrote:i know i have to pull the pieces under my taillights out for it but otherwise what all is involved.

those pieces are attached to your stock 00-02 bumper, just like the 03+. Only the 95-99 had the pieces seperate from the bumper.




SPD RCR Z - '02 Z24 420whp
SLO GOAT - '04 GTO 305whp
W41 BOI - '78 Buick Opel Isuzu W41 Swap

SpeedRacerZ wrote:

LAFNGAS wrote:i know i have to pull the pieces under my taillights out for it but otherwise what all is involved.

those pieces are attached to your stock 00-02 bumper, just like the 03+. Only the 95-99 had the pieces seperate from the bumper.

you are right, been super tired lately, thanks brian

wrong.. my 2002 z24 does not have the pieces under the tails attatched to the bumber. they are seperate pieces.