well shes back on her own feet for a bit till she has to go back in air lol still watein for downpipe flange and the pipe to get here then after thats made got to mout some gauges and hook up wide band and run water lines and vac lines get a tune

nice. what happened with those stall converters? are we going to see a gp?

very exciting stuff!!!

im going to get some more stalls made after my car is done ill have time to do it then if i was to do it now there be a lot of unhappy people due to it take me a wile to get them out to u after there done but should be good to go in a few weeks

well i got my pipe i order to make my downpipe today now only if the fuc*** down pipe flange would get here so i can make my downpipe and fire here up this weekend

is that at least 2.5" if thats for your dp?










~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ

its 2 1/2

thats the same boost gauge i have in my talon lol
what turbo are you runnin?

i still have no down pipe flange but i went on and tack welded up my down pipw let me know what u thank im going to wate to fully weld it till i get my down pipe flange and weld it on in case i need to fine adjust it as all

Not bad, only thing is with aluminized Id def recommend getting it coated or atleast high temp painting it when your done.

i want to coat it but cant find any one near owensboro ky that does it

There is a place in Lexington that does it and a few in cincy and Louisville too.The curve where the flange goes may not be tight enough may hit your thermostat housing or did you see if it was?

Coolness Overall and good updates! Cant wait for it to be running around, gets some vids when its all done!

well i got off work today at 10 today got my downpipe done and ready to go on and got my 3 gauge piller pod in the mail today going to try to fire the car up this weekend

sub'd. didnt see any of your older threads but excited to see this thing.