4T40-e bell housing bolts? - Transmission Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
4T40-e bell housing bolts?
Wednesday, February 28, 2007 3:46 PM
I will be bolting my engine to my engine stand SOON, and would like to know if anyone knew what size threads the bolts need to be? I Looked in my Haynes Manual and can not find the size. Any help would be great.




PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO

Re: 4T40-e bell housing bolts?
Wednesday, February 28, 2007 4:05 PM
i would say just use the tranny bolts and find a nut that will fit on the end.




Re: 4T40-e bell housing bolts?
Wednesday, February 28, 2007 4:29 PM
z yaaaa wrote:i would say just use the tranny bolts and find a nut that will fit on the end.

I do not have a tranny this is an extra motor that I bought off another org member.



PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search