Hey guys, At idle, Notice the old burning oil....

Iv read up on everything with the breathing of the engine, and yes, i had no modification too the AIR/OIL seperator, and was using stock intake manifold so that little pcv hole was not loooked after either, Now i was takin off the intake manifold today, and oil sorta dribbled out, now, ....Please dont tell me i have a blown head gasket...could oil being in their, be from the NO ventalation at all, or would it have to be the gasket gone, to let oil in.......I jus dont wanna install my new intake manifold and get everything good again, then realize i need a new head gasket...First off, Im gonna check my DP for oil leakage from turbo, but since i saw this oil in the Ports , im startin to think its not the turbo....ANy input at all on the subject....thanx guys

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>

A blown head gasket will not make the oil go in the manifold. bad valves seals or bad turbo seal(most likely) are the 2 probable cause.



Gilles
2.3 Ho

There is no oil in any of the charge pipes, so i dont see how the turbo can do it....i duno, anyone??

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>

im gonna check to see if its the turboes, exhaust side seal, which it probably is, and then go from there
, ill keep you guys updated, i think there is suppost to be alittle bit of oil when u take off the intake manifold im not sure, i had quiet abit. but its proly from the @!#$y vent i had going before


<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>