Alright, I figured this list would help. Thanks to Eric R. For supplying me with the list of items needed.

These are the parts that come with the GM SC. Minus the Carb sticker, which I couldn't find a number for at the time this was posted.

From first glance, it seems you're better off buying the ready made kit. GM wants an insane amount of money for some of the products needed, But maybe my math is wrong, feel free to check it.

And without further delay, Here is the parts list, prices and discontinuities for the 2.4 GM S/C m45 Supercharger.


-------------------------------------------------------


GM SC M45 PARTS LIST - 2.4 lD9



Bracket, S/C Support, Lower 88960232 -121.98

Bracket, S/C Support, Top 88960233 -39.46

Duct, Intake Air 88960234 -142.06

Bracket, S/C Snout Support, Lower 88960235 - 39.46

Bracket, S/C Snout Support, Upper 88960236 -39.46

Bracket, Cruise Control Relocation 88960480 105.18

Plug, Inlet Air Temparature Sensor 88960479 - 1.98

Adapter, Intake Air Duct 88960237 -DISCONTINUED

Hose Clamp, Hose for Reducer 10039976 - 9.42

Hose, PCV, Baffle to Intake Air Duct 09436383 - DISCONTINUED

Hose, EVAP to Throttle Body 09438315 - 97.58

Hose, MAP Sensor to S/C 12387951 - 50.30

Belt, Accessory Drive 88960481 - 193.72

Tube, Brake Booster to Throttle Body 58960482 - DISCONTINUED

Flat Washer, PCV Bent Tube 94127883 - 1.04

Bolt, Nose Support, Upper to Lower 24503664 - DISCONTINUED

Bolt, Idler to Lower Nose Support 11515755 - 4.84

Bolt, Top/Bottom Bracket to Manifold 11515756 - 0.74

Bolt, Manifold Flange 11508476 - 0.86

Bolt, Bottom Bracket to Block 11515769 - 4.84

Spiral Lock Washer, Lower Bracket to Block 11500046 - 0.74

External Tooth Lock Washer, Upper to Lower Support 11501869 - 4.30

Spiral Lock Washer, Top/Bottom Brackets to Manifold & PCV Bent Tube 09439511 - 0.74

Spiral Lock Washer, MAP Sensor & Cruise 09439510 - 6.44

Nut, Cruise Control Bracket 03530297 - 1.48

Sensor, MAP 09350899 - 225.75

Clamp, 5/8" hose 10293740 - 4.84

Decal, Accessory belt routing 88960577 - 17.62

Injectors, Fuel 17113399 132.74 (EACH?)

Spark Plugs 05613717 - 2.66 (EACH?)

Decal, Fuel Use 88960578 - 13.32

Nylon flex loom, Hose PCV Elbow to Intake Air Duct 88960622 - 4.56

Barbed Hose Coupler, EVAP Hose to Rubber Elbow 88960623 - 8.32

Wire loom, Aire Temp Sensor Wire 12051375 - 38.34

Baffle Assembly, PCV 88960484 - 499.41

Seal, PCV Baffle 88894217 - 25.90

Actuator, Supercharger By-pass 88960487 - 163.78

O-ring, Throttle Body 88960488 - DISCONTINUED

O-ring, Intake Manifold Runner 88960489 - 39.56

O-ring, PCV Port 88960490 - 4.46

Grommet, Air Temperature Sensor 15705446 - 1.42

Clamp, Air Temperature Sensor 88960491 - 7.18

Bolt, Air Temperature Sensor and MAP Sensor Mounting 52368558 - 1.68

Bracket Assembly, Idler 12498289 - 267.22

Pulley, Idler 88960493 - DISCONTINUED

Bearing, Idler Pulley 88960581 - DISCONTINUED

----------------------------------


-Rod

with the idler and the pulley for it discontinued

and the price of the pcv baffle


looks like your screwed trying to piece 1 together


and those of us with them , lets hope we can rig parts up as they go bad

yep. Proper @!#$.


Sorry guys, that's how it is.

oh by the way.


This is more or less to warn against buying incomplete kits here people...

I have armed you with knowledge. What you do with it is up to you.

Looks good man....you should add it to my sticky at the top!!!!



Car is for Sale!Supercharger kit is for sale!

I found the Baffle Assembly, PCV 88960484 for $269.95 at GM Parts Direct

you cant always count on gmpartsdirect , and their 25% shipping and handlng charge

Inari wrote:
GM SC M45 PARTS LIST - 2.4 lD9

Bracket, Cruise Control Relocation 88960480 105.18 Dont Need

Hose Clamp, Hose for Reducer 10039976 - 9.42 Dont Need

Hose, EVAP to Throttle Body 09438315 - 97.58 Dont Need

Hose, MAP Sensor to S/C 12387951 - 50.30 Dont Need

Wire loom, Aire Temp Sensor Wire 12051375 - 38.34Dont Need

-Rod

Also a few of the Discontinued items can be replaced by other items.




SPD RCR Z - '02 Z24 420whp
SLO GOAT - '04 GTO 305whp
W41 BOI - '78 Buick Opel Isuzu W41 Swap

Right.. but the brake booster tube and idler pulley are pretty important, aren't they?

... i made my own idler pulley when my stock one went bad, also re-enforced hose would work just fine as vac tube.

Chris


'02 Z-24 Supercharged
13.7 @102.45 MPH Third Place, 2007 GMSC Bash SOLD AS OF 01MAR08

The stock brake booster can be modified, you dont need the new GM one.



http://members.cardomain.com/vertz24 1998 Z24 Convertible

hey, does anyone need the smaller 2000+ 2.4 starter? ive got one here for 50bux and apparently its required if you have the 99 or older with the larger starter.

email me


farmerz24

the point is the important parts arent avaliable

and if your gonna b fabricating , why not fab up for a M62 or M90

because then your making a MANAFOLD, not just using a hose, and a pulley.


Chris


'02 Z-24 Supercharged
13.7 @102.45 MPH Third Place, 2007 GMSC Bash SOLD AS OF 01MAR08

the stock air/oil seperator should fit under the supercharger..... so dont need that either....

I think you can make it happen.




SPD RCR Z - '02 Z24 420whp
SLO GOAT - '04 GTO 305whp
W41 BOI - '78 Buick Opel Isuzu W41 Swap

ah well hopefully this knowledge is beneficial to some.

I'm saving up for the kit personally...

seems overly difficult to get some of these parts and the expense at which they come. Sure I figured that some parts are easier to get than others but this list is pretty good as far as how much gm will be able to help you get your stuff.

SpeedRacerZ wrote:the stock air/oil seperator should fit under the supercharger..... so dont need that either....

I think you can make it happen.

no it dosent, it hits the lower part the the manafold,

THAT could be a problem, hmmmmm

fab one up maby?


Chris


'02 Z-24 Supercharged
13.7 @102.45 MPH Third Place, 2007 GMSC Bash SOLD AS OF 01MAR08

Bump for possible stickyness? This list is still pretty current and accurate.

Also just because it is discontinued does not mean you can't get them either. Probably still some at dealers in stock. We were looking for 97 Blue carpet recently. The dealer said it was discontinued so we were like what we can't replace it if it neds to be. They said they have a number to call and they can track were any item had been ordered and sent, and if it sold. He said he was sure they would find some sitting somewhere. Might be worth people looking into now, and maybe buying some of those parts. Maybe people currently with chargers. I was also told by my GM contact that they had thousands of the charger kits sitting, and they have been talking of melting them down.



FU Tuning

nooo!

Melting? noo!

note the part number on the 2.4 kit GM 310cc supercharger injectors are actually ROCHESTER injectors p/n 25166922

You can find them here



1989 Turbo Trans Am #82, 2007 Cobalt SS G85

Melt them..
Sounds about right for GM
Clowns



Save a Tranny, Roll-on
15.3@88m.p.h.(I/E)
15.2@94m.p.h.(S/C'd)
15.5@89m.p.h.(Stock GTP)