hey not sure if its been answer previously or what but im building my motor for a turbo and wondering if i do all the internal goodies pistons,head work,gaskets, injectors,etc would i be able to run like that for a few monthes until i can slap the trubo kit on? would you see increase or decrease in power anything other then a gain at thjis point i might as well walk my biggest concern would be running large injectors and a high flow in tank fuel pump without having forced induction would that casue some unwanted issues? ps compression 8:9:1
Well, thats kind of a hard question to answer. Will you be safe? Yes, why not, since you just built it to take more punishment. Plus the fact that with bigger injectors and a new pump the most you can do is run it a little richer. You might have worse gas milage, but thats part of having a turbo anyway. So might as well get use to it. I dont know what you compression is stock but if you lowered the compression it will drive worse than before because you effectively lowered the torque output. If you raised the compression your not going to induce any more wear than the turbo itself could cause.
idk this might help you out, doesn't answer your ? but it is some good info, i found these prices 6 months ago some may be higher but they were cheapest at the time.
1. Eagle 2.2 OHV Connecting Rod-$350.00-Howell
2. Crane Roller Rocker Set for 98 up GM 2.2-$244.24-Howell
3. Crane GM 2.2 OHV Push Rods 98-up-$69.95-Howell
4. ARP Head Stud Kit-$159.95-JTuners
5. Car Customs Competition Valves 1mm Oversize-$100.00-Car Customs
6. Car Customs Upper/Lower Engine Mount Kit-$65.00-Car Customs
8. Front & Rear Transmission Mounts-$48.99-A+ Performance
9. Oil Cooler-$123.99-A+ Performance
10. Apexi S-AFC II Controller-$409.99-A+ Performance
11. B&M Racing Short Throw Shifter-$125.99-A+ Performance
12. 62 mm Throttle Body-$240.00+$100.00core charge-RSM
13. RSM Ported Intake Manifold-$200.00+$150.00core charge-RSM
14. WiseCo 2.2L Forged Steel Pistons-$596.00-JBP
15. Forced Induction 2.2L LN2 OHV Cam-280.00-JBP
16. MSD Fuel Pump-$129.99-RK Sport
17. Magnecor 8.5mm Igition Wire Set-$49.99-Gravana
18. Copper Head Gasket-126.40-JBP
19. SCE O-Ring Kit-$63.20-JBP
20. 2.2/2200 Crankshaft Lightening/Knife-Edge Service-$231.20-JBP
21. 2.2/2200 Crankshaft Balancing-$120.00-JBP
http://www.cardomain.com/id/oyyci
http://photobucket.com/albums/d170/Oyyci/
