I'm redoing my trunk setup and making a glass sub box in the spare tire well. How thick are you guy's making your boxes?

Don't tell me in layers please, tell me in fractions/mm's. I have 3 or 4 different thickness of mat and 5 different thickness of woven that I use to make all my vacuum form tools so I can control thickness pretty well.

I'll be running 2 JLw10v2's @ about 400watts each MAX and that won't be very often.





"The FACTS are always subject to CHANGE once the TRUTH is applied"
"In the entire history of man the only stupid questions are the ones that don't get asked"

1 CM and you should be good if you are using matte. just make sure that you layer in the corners so that the fibres roll around. ex. if you have 4 layers all cut to the same length and they all meet at the same point = bad. you want consistancy all around, tear the matte with your hands, dont cut it with scissors. it weaves it to make a strong bond.

If you are using fleece, SOAK it, the more resin you put in, the stronger its gonna be, you'll still need matte behind it (fleece + matte should equal 15mm aprx.)

thats my 2 cents.

1cm = .3937 = 3/8" That sounds pretty thick to me.






"The FACTS are always subject to CHANGE once the TRUTH is applied"
"In the entire history of man the only stupid questions are the ones that don't get asked"

1/4 inch should be plenty.

That's about what I was figuring. Thanks...





"The FACTS are always subject to CHANGE once the TRUTH is applied"
"In the entire history of man the only stupid questions are the ones that don't get asked"