Im trying to connect a Line Out Converter to the factory radio harness in my 2002 Sunfire (non-monsoon). I need to know what colors mean what on the factory harness. I have searched all over and have found a few charts, but each of them say different things. I want to know the correct color code is before I start splicing.
Constant 12V+ Orange
Switched 12V+ Yellow
Ground Black
Illumination Gray
Dimmer Brown
Antenna Trigger Pink
Antenna Right Front
Front Speakers 4" x 6" Doors
Left Front (+) Tan
Left Front (-) Gray
Right Front (+) Light Green
Right Front (-) Dark Green
Rear Speakers 6" x 9" Rear Deck
Left Rear (+) Brown
Left Rear (-) Yellow
Right Rear (+) Dark Blue
Right Rear (-) Light Blue
---------------------------------------------------------------
http://www.cardomain.com/id/lanman31337
Sponsored by:
JLCaudio.net
ok 2 questions. How can the yellow wire be both "switched 12+" and "left rear"?? And which one would I hook up my Remote Amp cable to??
Currently I have the LOC Connected to the + and - of the 2 rear speakers at the harness, and I have my Amp Remote wire connected to the purple wire, cause thats the closest I could find to pink. Is that right??
Amp Turn On PINK (+) RADIO HARNESS
LF Speaker (+) TAN
LF Speaker (-) GRAY
RF Speaker (+) LIGHT GREEN
RF Speaker (-) DARK GREEN
LR Speaker (+) BROWN
LR Speaker (-) YELLOW
RR Speaker (+) DARK BLUE
RR Speaker (-) LIGHT BLUE
as for the remote turn on wire...how does the wire test when you turn on the radio? if it goes hot when on and goes off with the radio, then yer good.
mecp certified installer#39272
I dont have a pink wire. Its an 02 sunfire, 2 door, without upgraded system if that helps. But their is no pink wire.
This is what I have....
Speaker Wires....
Light Blue
Dark Blue
Light Green
Dark Green
Brown
Tan
Yellow
Grey
__________________________________
Unknown Wires
Thick Orange
Purple
Thick Black
Thin Black
and another grey
that line makes it look like its my signature, but it isnt. just more wires. didnt wanna confuse anyone.
ok, again, how does the purple wire test?
mecp certified installer#39272
I dont have a multimeter.
i would forego any and all wiring endeavors 'till you pick one up. better yet, break down, spend 70 bucks and get a power probe.
mecp certified installer#39272
i guess i'll borrow a multimeter from someone. thx.
Might be a few days before I can get a multimeter. So does anyone know off the top of their heads which wire from the harness I would use??? it has to be one of the following wires.....
Thick Orange
Purple
Thick Black
Thin Black
grey
Any Ideas?? I tried the purple already and it dosent seem to be working. HELP.
here's the info i have...
A8
TAN
201
Left Front Speaker Output (+)
A9
GRY
118
Left Front Speaker Output (-)
A10
LT BLU
115
Right Rear Speaker Output (-)
A11
DK BLU
46
Right Rear Speaker Output (+)
A12
BLK
350
Ground
B1
ORN
340
Battery Positive Voltage
B2
--
--
Not Used
B3
PNK
314
Radio On Signal
B4
GRY
8
Instrument Panel Lamp Supply Voltage - 1
B5
BLK
250
Ground
B6
PPL
1672
Gain Control Signal
B7
--
--
Not Used
B8
BRN
199
Left Rear Speaker Output (+)
B9
YEL
116
Left Rear Speaker Output (-)
B10
DK GRN
117
Right Front Speaker Output (-)
B11
LT GRN
200
Right Front Speaker Output (+)
B12
--
--
Not Used
--------------------------------------------------------------
Offical dealer for the following-
SOUNDSTREAM
DB LINK
DB DRIVE
PANASONIC
GARMIN
ROSEN
SCOSCHE
XE DESIGNS
SOUNDGATE
PAC
LITEGLOW
