Does anyone have a pic of where they mounted the thingers?... sorry i forget the name now. I went to install mine today and i dont know excatly where to mount it


1998 Sunfire, 2.2L auto

The actuators?? I mounted mine in the big hole closest to the back edge of the door. I ran a mounting bar accross the hole and mounted the actuator to the back side so that they didnt hit the interior panel. So my actuators are actually almost inside the door. I then just ran the rod to the door lock, takes about 30 min to put the whole system in, Ive done this on an 05 and an 03.

30 min for the whole system? damn u must be an expert...took me 30 min just bending the rods to make them perfect....whole install was like 2 hours

lol i took me like an hour trin to figure out where to install the thing (never got it done anyways) then like 30 mins to get the wires run because of the freakin door holes then like 30 secs to rip everything back out because i have to extend all the wires to run right... yea this is a weeks worth project for me lol


1998 Sunfire, 2.2L auto

Not an expert, I just work in the 12V field. but these are a pretty simple install, probably one of the easiest I have done.

i think i just need time to sit down and look at it to figure everything out


1998 Sunfire, 2.2L auto

i had to extend my wires too...by about 3-4 feet (i also have lambos so u probably won't need to extend them THAT much), but yea, it was a full days work for me...about 1 hour planning, about 20 min pulling everything apart and about 2 hours install....really took my time though and had to troubleshoot quite a bit

i extanded mine around 3 feet so i know i have enough wire


1998 Sunfire, 2.2L auto