I just got my lotek triple pod and went to install it today and realized that the fittings on the back of my air gauges wont allow it to sit all the way into the pod, anyone have any suggestions if they themselves have their air ride gauges in a pillar pod?

its been discussed before. you can get 45 degree elbows i believe for them. i didnt bother with it and just put it in as best i could. it was a bitch to get the lines on the back of the gauges once i cut them but i managed to get them to fit and sit pretty flush.

Yea I was told to get the 45 degree elbows but since I have, and want push to connect fittings I cant find a 1/8" npt female elbow anywhere with 1/4" ptc

Here ya go bro, think this is what you are looking for.

http://www.airridefittings.com/store/index.php?main_page=index&cPath=106_54_78

Thank you very much dude I appreciate it

Moar Candy! LAWL wrote:its been discussed before. you can get 45 degree elbows i believe for them. i didnt bother with it and just put it in as best i could. it was a bitch to get the lines on the back of the gauges once i cut them but i managed to get them to fit and sit pretty flush.

i did the same. just shoved it in there and it sat flush

I made the fitting I needed from 2 diffeent ones I got at hydraulic repair shop in town and it clears it enough to sit flush and not kink the line like the 90 degree did, thans guys

Well ive tried 45's and 90's and they dont fit worth @!#$ and theres no way Im going back to barbed fittings

i just put my trpile pillar pod in today with my air gauges its was a pain to do i used 2 45 elbows and just cut into the back on my factory pillar trim and pushed it into place and its holding in place, its was a pain to get all 5 hose down behind the dash to, not a whole lot of room the push them thru.

kevin cabral wrote:i just put my trpile pillar pod in today with my air gauges its was a pain to do i used 2 45 elbows and just cut into the back on my factory pillar trim and pushed it into place and its holding in place, its was a pain to get all 5 hose down behind the dash to, not a whole lot of room the push them thru.

yea especially when you have them cut to fit, its a bitch. i spent a good 2 hours trying to do mine.

thats why I have unions and about 300 feet of air line haha

well i am know changing my location of my air gauage from the pillar to my dash trim panle in the center dash vents just cause my pillar pod kept popping out of place when i hit bumps.