So I've searched and havent found the answer to what I'm looking for so I figured I'de send it out there in hopes of some answers. I know the easiest place to run the lines for the rear is straight through the sides of the trunk so they stick out right at the fitting on the strut. My question is where is the best place to run the line for the front? Like wheres a good place to drill the holes to get the line under the car.? Thank you in advance for anyones help. Pictures of this would be greatly appreciated as well. Oh and I'm talking about the easystreet kit for a cavalier if that matters.
i drilled through the strut tower at its lowest point under the cabin...basically right behind the battery on one side and under the AC on the other
its worked great for 3 years with no problems....thats including one winter as well
Phil Thacker
JCO North President
i drilled through the strut tower at its lowest point under the hood...basically right behind the battery on one side and under the AC on the other
its worked great for 3 years with no problems....thats including one winter as well
Phil Thacker
JCO North President
what i did for the front was zip tie them in the wheel wells and ran them under the car. theres a rail on each side that runs straight back to the rear and i zip tied all along there. once i got to the rear, i ran it up the rear wheel well and drilled a hole in the back of the well which allowed both lines (front and rear) to run into the trunk
i did same as above. basicly it however you want and what you like the best. some people feel more comfortable with them ran inside the car and some like me dont care about it outside the car. i had zip ties break once and i draged through a line but kept a union on me just incase and just pulled over and fixed it right there
sorry no pics right now maybe later im off work so maybe i will go snap a few. check back later tonight
