Hello folks,

Got my handy dany port matched HO manifold here, and I'm at a lost for what to do about a gasket.
Normally I'd use the 2.3 gasket kit, hack it up a little and be on my way.

Well, don't wanna do that this time as the port matching is really well done.

So anyone with suggestions on what to use.
Or if anyone can offer up a couple gasket ideas or wanna make one up I'll pay

Or if any machin shops in the area that can do it I'll try to set something up with them.
Thanks,
-M



Remember....syringes go in the RED waste basket.