4" Vibrant performance velocity stack $40
3.5" street power vibrant performance muffler with vband welded. never ran $115
3.5" vband clamps 2 clamp co 1 vibrant $20 a piece
2.4 timing cover black $20
2.4 timing cover with 2 -10an bungs welded, powder coated black $50
factory radiator and fan $20
Right 00-02 headlight $20
Rk sport type j side skirts $60
2.4 dual core, double pass radiator -16 water line, with alum water neck, coolant res. that hides in the cowl, comes with -16 line on upper hose, -12 hose from coolant tank to rad. and 2 -6 coolant lines from the tank to the firewall. $550
cobalt 2 1/16 egt gauge with probe and wiring $100
cobalt 2 1/16 egt gauge no wiring $30
nitrous lines 24" long $20
moroso 2 wire spiral $10
used 35mm lifters $40
golden eagle vacuum block $20
10gal. fuel cell with sending unit. also comes with support frame work and sheet metal to go into jbo spare tire $340
eco s/cr and manifold. i also have a few brackets for it. I purchased a motor that had this on and there was water in the motor so im unsure of the life the s/cr lived, spins freely but i would have it checked out. $250
eco fuel rail $15
DC sport oil cap works on 2.4 $10
2.4 exhaust cam cap $5
small coolant tank with cap $20
rksport cf brake res. cover $15
black a pillars with single pod $25
stock 2.4 throttle body $10
mcmoney lower engine mount $110
2.4 stock fuel rail $10
2.4 motor mount plate has the engine hoist loop cut off, black powder coated $30
2.4 coil cover $10 each
blue 2.4 timing chain cover $20
2.3 timing chain housing and cover $30
2.3 double roller timing chain new $30
2.2 power steering pump $20
1/4 panel extension left $5
2.4 side winder setup, header uses a t3 flange and tial 44mm wastgate. to be able to use this you will have to swap to manual brakes and most likely have to move the location on the fire wall. Or you can cut the pipe and change the location of the turbo placement to be able to possilbly retain factory brakes.$350
Buy my stuff!!! CLICK
R.I.P. Brian Klocke, you will never be forgotten
How much are the lifters shipped to 44077?
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
jay $12 on shipping
mike $6 on shipping
Buy my stuff!!! CLICK
R.I.P. Brian Klocke, you will never be forgotten
I get paid Friday...and so should you. lol
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Shipping for the 2.4 timing cover with 2 -10an bungs welded to 15074
Jason
99 Z24
LG0/LD9 for Life
10 Year Bash Veteren
Where were the timing chain housing and cover when I bought the engine?
Does the dual core rad fit in the stock location? Pictures of it in the car, specifically the coolant res in the cowl. Very interested.
PSN ID: Phatchance249
jason $17
shawn i think they were both listed just didnt have pictures of them, but the rad fits in the stock location but im unsure of how the lower bar would need to be modified because i had a custom lower. heres a few pictures in the car.
Buy my stuff!!! CLICK
R.I.P. Brian Klocke, you will never be forgotten
Brandon I am sure they were listed, at the time I was going to run MCmoney's adjustable cam gear set so I wasn't in the market for them. Beyond that my real frustration is I recently bought those pieces non-powdercoated for basically that much. Definitely didn't mean my comment to sound angry at you or anything, I am very pleased with our past deal.
I'll 99% in for the radiator, tank and lines. I just need to look at remaining finances for the month and maneuver some funds around. Looks like fuel pump and injectors will have to wait for next month.
Shipping to same address you sent the motor, zip 97224? Same paypal address as before?
PSN ID: Phatchance249
Paypal sent for the 2.4 timing cover with 2 -10an bungs
Thanks Brandon
Jason
99 Z24
LG0/LD9 for Life
10 Year Bash Veteren
shawn shipping would be $78 paypal is still the same.
jason ok should be shipped out today.
Buy my stuff!!! CLICK
R.I.P. Brian Klocke, you will never be forgotten
Boosted2point4 wrote:shawn shipping would be $78 paypal is still the same.
jason ok should be shipped out today.
Thanks for the update Brandon.
Your check should be there today or tomorrow. Snail mail is unpredictable at times
Jason
99 Z24
LG0/LD9 for Life
10 Year Bash Veteren
Crazy interested in the eco SC pm me for more info please
Chris rod I really don't have any more info on it. It came on a motor I bought and that's about all I know.
Buy my stuff!!! CLICK
R.I.P. Brian Klocke, you will never be forgotten
Unfortunately I am going to pass on the duel pass rad setup. Not in the cards at this time with other family stuff happening. Good luck on the sale.
PSN ID: Phatchance249
will take the carbon fiber res cover
What type of water pump were you running with the dual pass radiator? Liking at the picture of the Turbo manifold it looks like a water pump is laying between the block and lower Rad mount.
"Oil Leak ? What oil Leak ? Oh, Thats Just The Sweat From All The HorsePower!!"
Eco rail shipped to 44109?
Brandon can you pm me your paypal email?
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
PAID!
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
damn, should have given you my paypal instead
Boosted2point4 wrote:shawn shipping would be $78 paypal is still the same.
jason ok should be shipped out today.
I received the timing chain housing today. Thanks again
Jason
99 Z24
LG0/LD9 for Life
10 Year Bash Veteren
cf res cover is sold,
dsm im running a electric water pump but the radiator can still be ran with a reg setup.
eco rail is $13 shipping
sorry mike was a busy weekend with the kids birthday.
np jason
Buy my stuff!!! CLICK
R.I.P. Brian Klocke, you will never be forgotten