I was looking at msd's web page and saw the dash hawk, It looks good and it cost just as much as a 6-1 wide band gauge. Ill put a link up for you guys that dont know about it it. I even called msd and asked about my 2002 ecotec and they say its universal. I just want opinions before I run out and spend all that cash.
MSD's Dash Hawk
Beware the Rouge Dragon.
Oddly I was told it would not work on certain obd2 cars.
I was looking at this and faq page and it says
"My vehicle is not on the supported list. Is it CAN compliant?
If you vehicle is not listed in the supported vehicles page, all is not lost! There are many vehicles being added/tested every day and it is hard to capture them all and keep them up to date, so a good way to see if your car has a CAN bus is the following:
Locate the OBDII connector. It is under the dash on the driver’s side of the vehicle, often either under the steering wheel or tucked up next to the driver’s side kick panel.
Look carefully at the plug with a flash light or other bright light source. If pins 6 and 14 have metal pins in them (i.e. are “populated”) then the vehicle has a CAN bus and DashHawk will most likely work with this vehicle. "
dash hawk faq
Beware the Rouge Dragon.
I for got to look earlyer and its cold out side, lol Ill look tomarow lol
Beware the Rouge Dragon.
if noone has looked by the time i get out of class and to the house i will check it on my 01 2.4l
yay!
I realy want one bad
lol same here, I know on the listing it says a 05 and 06 cobalts and 2003 ions with 2.2 ecotec's so its looking hopeful.
Beware the Rouge Dragon.
J-bodies dont have CAN-bus.
Built, bottled, ready for 11s. 14.446@93.74mph, 1.848 60' N/A.
Ahhhh yet another idea crashing into another ball of flames
Beware the Rouge Dragon.
http://www.vectormotorsports.com/ , contact those guys and see if there is any thing they can do
they do alot of programing , so they would know if its possible to get it to work
