I've got the header already.... just wondering what the diameter of the exhaust ports on the flange are so I can port match my spare head.

Thanks,
Wesley

Do you have a ruler or caliper?

I think that was a little to obvious....

I needed someone to check... hopefully someone who has one off there car... mine is installed right now and I'm not able to remove it at the moment

tube diameter wont help any ways

you got to match port location

again.... I asked for it on the flange... not tube....

thanks

as i said , you need the actual port location on the flange to match it to


or pretty much the 97-older 2.2 exhaust gasket

[quote=97cavie24ls(JDM&00s/c sedans™)]as i said , you need the actual port location on the flange to match it to


or pretty much the 97-older 2.2 exhaust gasket

Yup, But good luck porting your head to the obx, Its a rip off of the pacesetter and is universal between the 95-97 2.2and the 98+ 2200, Hard to explain but when you port match to the obx gasket you can run into the water ports in the head if your not careful

Now lets see how many toss up the ol flag so I can prove it.

mmmm ok... thanks guys... guess I'll have to pull it off to see