punching holes in my oil filter, PLEASE HELP! - Maintenance and Repair Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
punching holes in my oil filter, PLEASE HELP!
Sunday, August 14, 2005 7:19 AM
A few months back, I replaced my '96 2.2 motor with the 2200 out of a wrecked '00, and the swap went fine. Now, several months later I am starting to have a problem. I have gone through 2 oil filters in less than a week, and when I take them off the car they look like they have been beaten repeatedly in one spot with a hammer. I am assuming that when the motor rocks under hard acceleration, the filter is hitting something, but I can't figure out what. I have checked to make sure all of my motor mounts are tight, and they are, I just can't figure this out. The only other option that I have thought of is one of those oil filter reallocator kits, which I wouldn't mind doing, but I'm not sure if they make one for the Cavy. If anyone has seen this before, or has any other input, it would be greatly appreciated. Thanks




Re: punching holes in my oil filter, PLEASE HELP!
Sunday, August 14, 2005 7:33 AM
Are you sure you're not just crushing it when taking it off with the filter tool if that is what you use. I know the oil filter tool I have crushes the filter a little. Could be that.



Re: punching holes in my oil filter, PLEASE HELP!
Sunday, August 14, 2005 7:38 AM
no, I'm pretty sure that's not the case. the holes develop while the car is in motion




Re: punching holes in my oil filter, PLEASE HELP!
Sunday, August 14, 2005 4:53 PM
Hmmm. I don't know what to tell you then. I don't have the 2.2 so I am not really sure what is in the way there or what not. There should not be anything near it at all that is doing that I would guess.



Re: punching holes in my oil filter, PLEASE HELP!
Sunday, August 14, 2005 5:00 PM
put some paint on the filter mixed with motor oil...the paint will stay wet and mark what ever it hits. than youll know for sure.
Re: punching holes in my oil filter, PLEASE HELP!
Sunday, August 14, 2005 5:38 PM
sounds like a bad lower mount to me


see ya!

Re: punching holes in my oil filter, PLEASE HELP!
Sunday, August 14, 2005 6:32 PM
novaracer wrote:sounds like a bad lower mount to me



me too seeing as the 96 engines are in all sideways like and such


It's a four banger, you gotta bang it four times to get it goin'....
Re: punching holes in my oil filter, PLEASE HELP!
Wednesday, August 17, 2005 4:42 PM
thanks for all the feedback, especially the paint suggestion. the lower mount was cracked around the two rear mount bolts, and it was sitting close enough together, until the motor rocked, that I overlooked it until I used the paint. Thanks



Re: punching holes in my oil filter, PLEASE HELP!
Wednesday, August 17, 2005 4:54 PM
That is what I thought was the problem but you said the mounts were tight. LOL. I guess you ment something else. Good you got it figured out. Looks like Novaracer hit it right on the nose.



Re: punching holes in my oil filter, PLEASE HELP!
Saturday, August 20, 2005 9:51 PM
just gotta say that the paint suggestion was great...I'll be keeping that one in mind for sure.



Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search