I might start doing these on a regular basis depending on how it goes.
Below if a picture of a close up of one of the pieces to of a new product that will be released shortly. The first one to name the part will get a 50% off coupon towards that part once it goes on sale.
Hmm, ya got me.
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ
Insert Tapout motion here...!
Maybe a spacer of some sort, but I really have no idea.
---------------------------------------------------
4 Cams...32 Valves...5 Liters...This Could Get Fun!
Rear disk brake bracket.....
?
id go with a caliper cover but too many holes and not sure how it would bolt up. otherwise its a foot gas pedal
looks to me like its some sort of billet dress up piece.
adaptor flange?.....maybe a piece of metal?
a very weird battery tie down.
WiGM-Tuners member.
probably something for an ecotec. go figure.
Needing 2.3 oil pump stuff? PM me...
Is it a water heater? No no wait wait , A snow cone maker....
a spell checker
Edited 1 time(s). Last edited Tuesday, February 03, 2009 9:11 AM
flux capacitor?
if not then im totally lost.
Seat brackets?
Tinkles
v. intr.
1. To make light metallic sounds, as those of a small bell.
2. Informal To urinate.
v. tr.
1. To cause to tinkle.
2. To signal or call by tinkling.
n.
1. A light, clear metallic sound or a sound suggestive of it.
2. An act or instance of tinkling.
muffler bearings!! I have no clue
I'm still going with my guess I have on EF.
looks like the bracket for a triple tree on a motorcycle?
If there were only 2 holes and they werent machined for bolt heads Id say it kinda looks like the end of a strut tower brace.
Zs Z wrote:If there were only 2 holes and they werent machined for bolt heads Id say it kinda looks like the end of a strut tower brace.
ha ha... thats what I suggested over on EF forums along with possibility of the solid upper eco engine mounts...
But more I think about it...
Given the provided picture above, its hard to access the actual size of that bracket.
Center hole would be used for mounting the tie support bar which runs across the engine bay to the other side. It would go alone nicely with their new Pillow ball mounts he's got coming out.
Edited 1 time(s). Last edited Tuesday, February 03, 2009 11:08 AM
thats what i was going to guess until i looked to the far right of his pic. why would it start trailing back out again though? and how do you tighten it down also if the head or the bolt is in there tight?
My Cats breath smells like Catfood
